40.5 MOTM - Style Parts
copy from wiseguy synth:
Here are a variety of miscellaneous MOTM-style parts that I use.
Ferrite Beads | Supplier | Part Number |
Short ferrite beads | Mouser | 623-2743001112LF |
Long ferrite beads | Mouser | 623-2743002112LF |
Capacitors | ||
22 µF 35V low leakage electrolytic capacitor | Mouser | 647-UKL1V220KEDANA |
10 µF 35V low leakage electrolytic capacitor | Mouser | 647-UKL1V100MDDANA |
0.1 µF ceramic decoupling capacitor | Mouser | 147-72-104-RC |
DIP Sockets | ||
8 pin DIP | Mouser | 517-4808-3000-CP |
14 pin DIP | Mouser | 517-4814-3000-CP |
16 pin DIP | Mouser | 517-4816-3000-CP |
Panel connectors | ||
1/4" NC panel mount jack | Bridechamber | |
MIDI connectors (silver) | Mouser | 16HR655 |
MIDI connectors (black) | Mouser | 164-2522 |
MTA power connectors | ||
4 pin 0.156 MTA header (PCB) | Mouser | 571-6404454 |
4 pin 0.156 MTA connector (cable) | Mouser | 571-3-640426-4 |
4 pin 0.156 MTA dust cap | Mouser | 571-6405514 |
Note: these next two parts are for daisy-chain feed-through power cables | ||
4 pin 0.156 MTA thru connector (cable) | Mouser | 571-3-640599-4 |
4 pin 0.156 MTA thru dust cap | Mouser | 571-6406434 |
MTA signal connectors | ||
Note: the last digit specifies the number of pins | ||
2 pin 0.1 MTA header | Mouser | 571-6404542 |
2 pin 0.1 MTA connector | Mouser | 571-3-640441-2 |
2 pin 0.1 MTA dust cap | Mouser | 571-6405502 |
FCI signal connectors (e.g. Berg) | Mouser | |
Note: use where limited space for MTA connectors | ||
0.1" female receptacle (connectors) | Mouser | 649-48235-000LF |
2 pin connector housing | Mouser | 649-65039-035LF |
3 pin connector housing | Mouser | 649-65039-034LF |
Tempco SMT Resistors | Supplier | Part Number |
68R 3300PPM 5% 0805 resistor | Digikey | P68CDCT-ND |
1K 3300PPM 5% 0805 resistor | Digikey | P1.0KCDCT-ND |
1K8 3300PPM 5% 0805 resistor | Digikey | P1.8KCDCT-ND |
potentiometer updated 2018:
P260P-D1BS3CA100K 100k log 20mm
P260P-D1BS3CB100K (update 2018) 20mm
P260P-D1BS4A B-100 voeklner 100k lin 24mm (too) long
LED LENS MOTM STYLE
RED: 67-1155-ND mouser
Green: 67-1156-ND mouser
Yellow : 67-1157-ND mouser
mounting parts
spacer 534-398 mouser 0,167 in outside 4,2mm wrong
534-405 0,193in outside, 0,25in lenght 4,9mm wrong
534-412 0,232in outside 0,254in lenght 5,9mm
screws: 534-9409 mouser
4ea #8-32 x 3/8 black screws
(for mounting module to rack)
4ea #6-32 x 3/8 zinc screws (for
attaching pc board to bracket)
4ea 1/8 inch aluminum spacers
6ea #6 KEPS nuts
Related content
how to bugfix: https://diysynth.wiki.dsl-man.de/wiki/spaces/SKM/pages/336101402/How+to+bugfix
non commercial pages, all infos are best can do without warranty, without liability.