copy from wiseguy synth:
Here are a variety of miscellaneous MOTM-style parts that I use.
| Ferrite Beads | Supplier | Part Number | ||
| Short ferrite beads | Mouser | 623-2743001112LF | ||
| Long ferrite beads | Mouser | 623-2743002112LF | ||
| Capacitors | ||||
| 22 µF 35V low leakage electrolytic capacitor | Mouser | 647-UKL1V220KEDANA | ||
| 10 µF 35V low leakage electrolytic capacitor | Mouser | 647-UKL1V100MDDANA | ||
| 0.1 µF ceramic decoupling capacitor | Mouser | 147-72-104-RC | ||
| DIP Sockets | ||||
| 8 pin DIP | Mouser | 517-4808-3000-CP | ||
| 14 pin DIP | Mouser | 517-4814-3000-CP | ||
| 16 pin DIP | Mouser | 517-4816-3000-CP | ||
| Panel connectors | ||||
| 1/4" NC panel mount jack | Bridechamber | |||
| MIDI connectors (silver) | Mouser | 16HR655 | ||
| MIDI connectors (black) | Mouser | 164-2522 | ||
| MTA power connectors | ||||
| 4 pin 0.156 MTA header (PCB) | Mouser | 571-6404454 | ||
| 4 pin 0.156 MTA connector (cable) | Mouser | 571-3-640426-4 | ||
| 4 pin 0.156 MTA dust cap | Mouser | 571-6405514 | ||
Note: these next two parts are for daisy-chain feed-through power cables | ||||
| 4 pin 0.156 MTA thru connector (cable) | Mouser | 571-3-640599-4 | ||
| 4 pin 0.156 MTA thru dust cap | Mouser | 571-6406434 | ||
| MTA signal connectors | ||||
Note: the last digit specifies the number of pins | ||||
| 2 pin 0.1 MTA header | Mouser | 571-6404542 | ||
| 2 pin 0.1 MTA connector | Mouser | 571-3-640441-2 | ||
| 2 pin 0.1 MTA dust cap | Mouser | 571-6405502 | ||
| FCI signal connectors (e.g. Berg) | Mouser | |||
| Note: use where limited space for MTA connectors | ||||
| 0.1" female receptacle (connectors) | Mouser | 649-48235-000LF | ||
| 2 pin connector housing | Mouser | 649-65039-035LF | ||
| 3 pin connector housing | Mouser | 649-65039-034LF | ||
| Tempco SMT Resistors | Supplier | Part Number |
| 68R 3300PPM 5% 0805 resistor | Digikey | P68CDCT-ND |
| 1K 3300PPM 5% 0805 resistor | Digikey | P1.0KCDCT-ND |
| 1K8 3300PPM 5% 0805 resistor | Digikey | P1.8KCDCT-ND |
pot
potentiometer updated 2018:
P260P-D1BS3CA100K 100k log 20mm
P260P-D1BS3CB100K (update 2018) 20mm
P260P-D1BS4A B-100 voeklner 100k lin 24mm (too) long
LED LENS MOTM STYLE
RED: 67-1155-ND mouser
Green: 67-1156-ND mouser
Yellow : 67-1157-ND mouser
mounting parts
spacer 534-398 mouser 0,167 in outside 4,2mm 
wrong
534-405 0,193in outside, 0,25in lenght 4,9mm wrong
534-412 0,232in outside 0,254in lenght 5,9mm 
screws: 534-9409 mouser
4ea #8-32 x 3/8 black screws
(for mounting module to rack)
4ea #6-32 x 3/8 zinc screws (for
attaching pc board to bracket)
4ea 1/8 inch aluminum spacers
6ea #6 KEPS nuts